Page 2 of 3
Re: Assembly: Pilot RC 40% Extra 330SC
Posted: Wed Oct 14, 2015 9:06 pm
by cherrybomb48
Re: Assembly: Pilot RC 40% Extra 330SC
Posted: Thu Oct 15, 2015 3:46 pm
by Xpress
Pilot ships all of their airplanes with the ailerons and elevators already hinged. Rudder/vertical stab has the hinges installed, but it's removable via wire that clamps in place. Control horns and misc. hardware are all inside of individual bags, you may want to swap the axles, wheels, and tailwheel assembly for something better (White Rose). Otherwise it's a very complete ARF airplane, very well built.
Are you going to run more Hitec HSB's on it? Hitec brushless are among the only brushless servos that draw significantly less power than an equivalent coreless, and also have the constant torque output.
Re: Assembly: Pilot RC 40% Extra 330SC
Posted: Thu Oct 15, 2015 4:01 pm
by Xpress
Or you could also take a look at our new D-950TW's!!! 32 bit chip (that's 4x the resolution of the HSB servos
), ultra precise centering and incredibly smooth movement. Seen a couple of them and their operation is insanely smooth.
Re: Assembly: Pilot RC 40% Extra 330SC
Posted: Thu Oct 15, 2015 5:24 pm
by Joe Hunt
Re: Assembly: Pilot RC 40% Extra 330SC
Posted: Thu Oct 15, 2015 5:25 pm
by Joe Hunt
Re: Assembly: Pilot RC 40% Extra 330SC
Posted: Fri Oct 16, 2015 8:37 am
by Xpress
Re: Pilot RC 40% Extra 330SC
Posted: Fri Oct 16, 2015 8:44 am
by Xpress
But if you are thoroughly enjoying the brushless servos then there's no reason to change. Stick with them and huck down low!!
Re: Pilot RC 40% Extra 330SC
Posted: Mon Oct 19, 2015 2:06 pm
by Joe Hunt
Plane delivers tomorrow!
When will you have the 9380s in stock, Xpress?
Re: Pilot RC 40% Extra 330SC
Posted: Mon Oct 19, 2015 4:26 pm
by Xpress
Re: Pilot RC 40% Extra 330SC
Posted: Mon Oct 19, 2015 4:52 pm
by Joe Hunt
Could you be more cryptic?! Doh! haha
Don't worry, I talked to Mr. Mayberry...
