Re: Aeroworks QB 150cc YAK 55M
Posted: Sat Aug 15, 2015 2:59 pm
Okay, the JR servos showed up today. The wing hardware that Aeroworks includes in the QB is in the background. AW gives you steel pushrods with a tool, quality balljoints and quality nuts and bolts. AW uses these pushrods and the plastic Hitec servo arms that come with the Hitec servos with no problems whatsoever, and AW test pilots fly their surfaces harder than me, for sure. But, for me, I'm going with titanium pushrods and all stainless steel nuts and bolts from www.microfasteners.com . They clean up easy and look real nice.
Looks like 3" is the right length on the pushrods (I'll verify that later during the installation) and I have those in standard H9. I'd like to get them in blue from Team Associated, we'll see if that gets done. haha Also I think the DUBRO blue ball joints will look cool, so I am going with those:
I'm using the included AW control horns because I like the way they spread the load out over the hard point. I like a single bolt better, but I'd have to put in my own hard point to be sure if I was going to use a single bolt. And, again, that is the wrong length blue pushrod, but I want to go blue if I get around to it. haha
![Smile :)](./images/smilies/icon_e_smile.gif)
I'm using the included AW control horns because I like the way they spread the load out over the hard point. I like a single bolt better, but I'd have to put in my own hard point to be sure if I was going to use a single bolt. And, again, that is the wrong length blue pushrod, but I want to go blue if I get around to it. haha